- Rated for 35 hp power and smaller motors
- 5 1/2" Set Back to Enhance Boat Stability and Performance
- 1/4" 6061 T6 Extruded Aluminum Construction with Stainless Steel Fasteners
- Accommodates Clamp-on or Bolt-on Motors Without the Need of an Adapter
- Weighs Only 24 Pounds
Electric Hydraulic Tilt & Trim
You Get Power Tilt & Trim, Better Boat Handling, More Speed, Lower Fuel Consumption and No More Back Strain!
Note: The inside dimension of the motor mounting area of the PT-35 is 11 inches. Before ordering, please make sure that the maximum width of the clamp mounting feet and/or mounting bolts of the motor that must fit into this area does not exceed this 11 inch limit. Refer to the transom view drawings. Mounting bolts are not included with the PT-35.
|OEM/Bulk||Product Name||Distributor Packaged||
|52100||CMC, PT-35 Tilt & Trim, up to 35 HP (gauge not available)|
- Power rating: up to 35 hp
- Set Back: 5 1/2"
- Trim and tilt: 84°
- Inside dimension of the motor mounting area: 11"
- Electric hydraulic actuator rating: 7853 lbs. of thrust
- Weight: 24 lbs
Service was top notch
It came quickly. Almost have the CMC 35 mounted. Had to wait on parts from other sources.
Address was typed in wrong on package. Took a little longer to deliver because of this issue but Unit works as should. Love how small it is and trims very fast. Ran wires to a Yamaha big tiller. Very easy install. Highly recommend this PT-35 if you are in the market for a smaller size trim unit.
Purchased and installed the PT-35 power trim/tilt on my 2009 Alumacraft with 25 HP 4-stroke Suzuki outboard approximately 9-10 years ago and still working as advertised.Well constructed piece of equipment.Installation was easy as long as you pay attention to and follow the instructions.I hardest part for me was driving 20 miles roundtrip to rent a lift to move the motor from the boat to install the PT-35 otherwise it was a snap.
Have not installed it yet but have friends who have one.