- Rated for 35 hp power and smaller motors
- 5 1/2" Set Back to Enhance Boat Stability and Performance
- 1/4" 6061 T6 Extruded Aluminum Construction with Stainless Steel Fasteners
- Accommodates Clamp-on or Bolt-on Motors Without the Need of an Adapter
- Weighs Only 24 Pounds
Electric Hydraulic Tilt & Trim
You Get Power Tilt & Trim, Better Boat Handling, More Speed, Lower Fuel Consumption and No More Back Strain!
Note: The inside dimension of the motor mounting area of the PT-35 is 11 inches. Before ordering, please make sure that the maximum width of the clamp mounting feet and/or mounting bolts of the motor that must fit into this area does not exceed this 11 inch limit. Refer to the transom view drawings. Mounting bolts are not included with the PT-35.
|CMC, PT-35 Tilt & Trim, up to 35 HP (gauge not available)
- Power rating: up to 35 hp
- Set Back: 5 1/2"
- Trim and tilt: 84°
- Inside dimension of the motor mounting area: 11"
- Electric hydraulic actuator rating: 7853 lbs. of thrust
- Weight: 24 lbs
Quick and accurate delivery by TH Marine. My boat would plane quickly but "plow" at speed with the motor tilted down. Conversely, it was hard to plane with the motor tilted up a hole or two, but ran well at speed. This gives me the best of both worlds.
That said, mounting the motor was a pain. The upper bolt holes for a Yamaha ESH30 just clip the bracket's spacer for the clamps, and one of the lower holes would result in the bolt head fouling the tilt motor. It required three custom spacers be made, but this is probably unique to the Yamaha bolt pattern.
Service was top notch
It came quickly. Almost have the CMC 35 mounted. Had to wait on parts from other sources.
Address was typed in wrong on package. Took a little longer to deliver because of this issue but Unit works as should. Love how small it is and trims very fast. Ran wires to a Yamaha big tiller. Very easy install. Highly recommend this PT-35 if you are in the market for a smaller size trim unit.
Purchased and installed the PT-35 power trim/tilt on my 2009 Alumacraft with 25 HP 4-stroke Suzuki outboard approximately 9-10 years ago and still working as advertised.Well constructed piece of equipment.Installation was easy as long as you pay attention to and follow the instructions.I hardest part for me was driving 20 miles roundtrip to rent a lift to move the motor from the boat to install the PT-35 otherwise it was a snap.