- Fits Over Trim Rams
- Supports Your Outboard While Trailering
- Takes the Pressure Off of Hydraulic System
- Most Outboards 150hp and Up
- Strong Aluminum Tubing with Molded Ends
- Safe for Salt or Fresh Water
- 8 1/2" Long
Whether you refer to it as an H Bracket, a motor toter, a transom saver, or a motor support, this MOTOR STIK™ Outboard Motor Support Stick will help save your boat and save your motor.
NOTE: Some Yamaha motors have a grease fitting on the port side ram. Use a single Motor Stik™ on the starboard side only in this application.
**Not compatible with 2024 Mercury outboards
- Length: 8 1/2"
- Material: Aluminum
- Capacity: Most Outboards 150hp and Up
- UPC: 733572067750
I ordered these for my 150 Evinrude G2 but they do not fit. The description should state these will not fit Evinrude. I’ll have to modify these to fit. The plastic end caps are too narrow and have been removed and alternative caps will have to be made
They took a while to get here as they were returned to sender but they are here and worth the wait.
First time I used this toter rods the black tops on the top side were cut into when I got to boat launch when I took them off at the pre launch area
Adequate but not as snug as would like.